Q-Logic 16-Feb ユーザーズマニュアル
2 – General Description
Fans
Fans
2-10
59021-06 A
D
Each power supply is capable of providing all of the switch’s power needs. During
normal operation, each power supply provides half of the demand. If one power
supply goes offline, the second power supply steps up and provides the
difference.
normal operation, each power supply provides half of the demand. If one power
supply goes offline, the second power supply steps up and provides the
difference.
The power supplies are hot swappable and interchangeable. Hot swappable
means that you can remove and replace one power supply while the switch is in
operation without disrupting service.
means that you can remove and replace one power supply while the switch is in
operation without disrupting service.
Each power supply has two status LEDs: an Output Power LED (green) and an
Over Temperature LED (amber):
Over Temperature LED (amber):
The Output Power LED illuminates to indicate that the power supply is
producing DC voltage at the proper levels.
producing DC voltage at the proper levels.
The Over Temperature LED illuminates to indicate that the power supply is
overheating. When a power supply overheats, the switch extinguishes the
Output Power LED and shuts down the power supply. Refer to
overheating. When a power supply overheats, the switch extinguishes the
Output Power LED and shuts down the power supply. Refer to
for information about troubleshooting
over temperature conditions.
2.6
Fans
. If one fan should
fail, the other fan is capable of providing the necessary cooling until the failed fan
can be replaced. The fans are hot swappable and interchangeable. Refer to
can be replaced. The fans are hot swappable and interchangeable. Refer to
for information about removing and replacing the fans. Air flow
can be front-to-back or back-to-front depending on the switch model.
Figure 2-10. Fans
Fans