Multi-Tech Systems MVP210-SS ユーザーズマニュアル

69 

 
Cabling involves connecting the MultiVOIP to your LAN and telephone 

equipment.  
1. 

.  If all channels of your MultiVOIP will be 

using either FXS, FXO, or E&M telephony interfaces, skip to step 2. 
For any channel on which you are using the DID interface type, you 

must change the jumper on the MultiVOIP circuit card. 

  a. Disconnect power.  Unplug the AC power cord from the wall outlet 

or from the receptacle on the MultiVOIP unit. 

  b. Using a #1 Phillips driver, remove the three screws (at back of unit) 

that attach the main circuit card to the chassis of the MultiVOIP. 

Screws (3) holding circuit card assembly to chassis.

 

   

c. Pull the main circuit card out about 5 inches (the power 

connection to the board prevents it from being removed entirely 

from the chassis).