Multi-Tech Systems MVP210-SS ユーザーズマニュアル

70 

d. Identify the channels on which the DID interface will be used. 

For DID

Interface type

For non-DID

Interface type

Ch 1

Ch 2

Ch 3

Ch 4

Jumpers 1-4

}

}

U9

U7

U8

U10

Ch 5

Ch 6

Ch 7

Ch 8

Jumpers 5-8

Jumper Configurations

(enlarged)

Generality:

For channels using the DID

interface, the jumper must
not straddle across the

cross-hatched area between

the jumper posts.

For channels using any non-DID

interface, it is acceptable that the

jumper straddles across the

cross-hatched area between

the jumper posts.

 

e. Position the jumper for each DID channel so that it does not connect 

the two jumper posts.  For DID operation of a voip channel, the 

MultiVOIP will work properly if you simply remove the jumper 

altogether, but that is inadviseable because the jumper might be 

needed later if a different telephony interface is used for that voip 

channel. 

f. Slide the main circuit card back into the MultiVOIP chassis and 

replace the three screws.