Multi-Tech Systems MVP210-SS ユーザーズマニュアル

73 

8. Ensure that the unit is properly connected to earth ground by 

verifying that it is reliably grounded when mounted within a rack.  
This can be accomplished by connecting a grounding wire between 

the chassis grounding screw (see Figure 3-9) and a metallic object that 

will provide an electrical ground. 

9. Turn on power to the MultiVOIP by placing the ON/OFF switch on 

the back panel to the ON position. Wait for the Boot LED on the 

MultiVOIP to go off before proceeding. This may take a few minutes. 

  Proceed to Chapter 4 to load the MultiVOIP software. 
 

Cabling involves connecting the MultiVOIP to your LAN and telephone 

equipment.  
1. 

.  If both channels of your MVP210-SS 

MultiVOIP will be using either FXS, FXO, or E&M telephony 

interfaces, skip to step 2. 
For any channel on which you are using the DID interface type, you 

must change the jumper on the MultiVOIP circuit card. 

  a. Disconnect power.  Unplug the AC power cord from the wall outlet 

or from the receptacle on the MultiVOIP unit. 

  b. Using a #1 Phillips driver, remove the screw (at bottom of unit, 

near the back-cover end) that attaches the main circuit card to the 

chassis of the MVP210-SS. 
c. Pull the main circuit card out about half way.