Xerox SquareFold ユーザーズマニュアル
Overview
3
SquareFold Trimmer User Guide
1.
2.
3.
5.
6.
4.
1.
2.
3.
5.
4.
6.
The booklet leaves the booklet area of the finisher and enters
SquareFold Trimmer Module.
SquareFold Trimmer Module.
Once the booklet spine reaches the square fold area, the
booklet is clamped and the square-folding operation begins.
booklet is clamped and the square-folding operation begins.
The booklet is flattened and the spine squared according to
the square-fold setting indicated on the control panel.
the square-fold setting indicated on the control panel.
For detailed information on each of Square Fold settings,
refer to page 6.
refer to page 6.
After the booklet is flattened and the spine squared, it is
moved to the trimmer area.
moved to the trimmer area.
The booklet then moves to the exit area where it is
transported to the Booklet Output Tray.
transported to the Booklet Output Tray.
Paper path
The Booklet Exit sensor (in the SquareFold Trimmer Module)
detects the lead edge (spine) of booklet and moves the
booklet to square fold area.
detects the lead edge (spine) of booklet and moves the
booklet to square fold area.
Based on the finished booklet size, the booklet is moved
until the trail edge reaches the trimmer cutter.
until the trail edge reaches the trimmer cutter.
The trail edge is trimmed/cut (based on the finished
booklet size entered for the Trimmer Mode Setting).
booklet size entered for the Trimmer Mode Setting).
1.
2.
3.
4.
5.
a.
b.
6.
Tip: Booklets exiting/leaving the SquareFold Trimmer
Module may contain trim remnants/scraps from the
previously trimmed booklet. This is due to static electricity
build-up and is normal. If booklets contain trim
remnants/scraps, simply remove and discard them.
Module may contain trim remnants/scraps from the
previously trimmed booklet. This is due to static electricity
build-up and is normal. If booklets contain trim
remnants/scraps, simply remove and discard them.