National Instruments 3.22E+04 ユーザーズマニュアル

© National Instruments Corporation

pin descriptions (table), 2-15
pin locations (figure), 2-14

pin descriptions (table), 2-13
pin locations (figure), 2-12

(figure), 2-1, B-3

dialog box (figure), 3-3
transceiver mode, 3-4
using FIFO buffers, 3-4

four-wire mode, 4-2
setting transceiver control mode, 4-3
transceiver mode control bytes (table), 4-4
transceiver mode control modes (table), 4-2
two-wire mode: DTR controlled, 4-2
two-wire mode: DTR with Echo, 4-2
two-wire mode: TXRDY auto control, 4-3

cable connection, 2-7
changing communication port settings, 3-1
changing resources assigned to serial 

determining port associated with 

COMx, C-6

diagnostic test failure, C-6
maximum supported baud rate, C-7
naming National Instruments serial 

communication port settings configuration, 3-1
configuration, 3-1
conflict-free resources, C-2

connecting cables, 2-7
connecting cables to four-port PCI serial board 

connecting two-wire devices, 2-15
conventions, xi
customer education, E-1