Справочник Пользователя для National Instruments 3.22E+04

© National Instruments Corporation

I-1

PCI Serial for Windows Me/9x

Index

Numerics

100-pin connector, 2-14

pin descriptions (table), 2-15
pin locations (figure), 2-14

10-position modular jack, 2-9

pin descriptions (table), 2-9
pin locations (figure), 2-9

68-pin connector, 2-12

pin descriptions (table), 2-13
pin locations (figure), 2-12

A

add/remove programs properties dialog box

(figure), 2-1, B-3

advanced port settings, 3-3

dialog box (figure), 3-3
transceiver mode, 3-4
using FIFO buffers, 3-4

advanced transceiver control for the

four-wire mode, 4-2
setting transceiver control mode, 4-3
transceiver mode control bytes (table), 4-4
transceiver mode control modes (table), 4-2
two-wire mode: DTR controlled, 4-2
two-wire mode: DTR with Echo, 4-2
two-wire mode: TXRDY auto control, 4-3

B

bias resistors, A-5

using in transmission line (figure), A-6

bits per second, 3-3

C

cable connection, 2-7
changing communication port settings, 3-1
changing resources assigned to serial

common questions, C-6

changing resources assigned to serial

determining port associated with

determining type of serial hardware

determining version of NI-Serial software

diagnostic test failure, C-6
maximum supported baud rate, C-7
naming National Instruments serial

removing information about serial boards

from Device Manager, C-7

communication port settings, 3-1

viewing or changing, 3-1

communication port settings configuration, 3-1
configuration, 3-1
conflict-free resources, C-2

connecting cables, 2-7
connecting cables to four-port PCI serial board

connecting two-wire devices, 2-15
conventions, xi
customer education, E-1