ZyXEL Communications n/a ユーザーズマニュアル
Chapter 21 WAN Commands
DSL & IAD CLI Reference Guide
163
21.6 wan node Commands
Use these commands to configure the WAN ISP and backup nodes.
Table 66 wan node Commands
COMMAND
DESCRIPTION
wan node backup <enable|disable>
Activates or deactivates the backup WAN node.
Note: Use the wan node index 9
command to specify the backup
WAN node.
WAN node.
wan node backup filter
<incoming|outgoing> <profile>
Sets the filter action and profile to be used by the
previously-specified WAN backup node.
previously-specified WAN backup node.
incoming
: the filter applies to traffic coming from
the WAN to the LAN.
outgoing
: the filter applies to traffic coming from
the LAN to the WAN.
profile
: profile number 1 ~ 4. Use the sys
filter set
commands to configure filter profiles.
wan node backup idletimeout
<seconds>
Sets the idle timeout for the previously-specified
WAN backup node.
WAN backup node.
wan node backup ispname <name>
Sets the ISP name for the previously-specified WAN
backup node.
backup node.
wan node backup metric <metric>
Sets the metric value (number of transmission hops)
for the previously-specified WAN backup node.
for the previously-specified WAN backup node.
wan node backup multicast
<none|igmpv1|igmpv2>
Sets the multicast mode of the previously-specified
WAN backup node.
WAN backup node.
wan node backup nailedup <on|off>
Activate or deactivate a nailed-up (always on)
connection for the previously-specified WAN backup
node.
connection for the previously-specified WAN backup
node.
wan node backup nat <off|sua|full
<address mapping rule #>>
Sets the Network Address Translation (NAT) mode
of the previously-specified WAN backup node.
of the previously-specified WAN backup node.
<off>
: NAT is not active
<sua>
: Use Single User Account only (if you have
just one public WAN IP address for your ZyXEL
Device).
Device).
<full>
: Use full-feature NAT (if you have multiple
public WAN IP addresses for your ZyXEL Device).
<address mapping rule #>
: When you choose
full-feature NAT, specify the address mapping rule
to apply. Use the ip nat addrmap rule
command to configure address mapping rules.
to apply. Use the ip nat addrmap rule
command to configure address mapping rules.
wan node backup ppp authen
<chap|pap|both>
Sets the authentication method for the backup WAN
node (use the wan node index 9 command to
specify the backup WAN node).
node (use the wan node index 9 command to
specify the backup WAN node).
wan node backup ppp idletime
<seconds>
Sets the PPP idle timeout for the previously-
specified backup WAN node.
specified backup WAN node.
wan node backup ppp password
<password>
Sets the password for the previously-specified
backup WAN node.
backup WAN node.
wan node backup ppp username <name>
Sets the username for the backup WAN node (use
the wan node index 9 command to specify the
backup WAN node).
the wan node index 9 command to specify the
backup WAN node).