Shark S3250W 11 ユーザーズマニュアル

 1-800-798-7398

www.sharkclean.com

English

IMPORTANT: Your steam mop needs 
water to make steam!  Never use 
your steam mop without water in the 
tank.

Sweep or vacuum your floors prior 
to cleaning with your 

Light & Easy™ 

Steam Mop.

 

Visit 

www.sharkclean.com for other 

great quick cleaning products to 
complement your 

Light & Easy™ 

Steam Mop, such as the Shark

®

 

SV800 Cordless Stick Vac.

  Pull and twist the quick release 

cord holder to unwrap the power 
cord completely. (

fig. 1)  Plug into 

a 120-volt electrical outlet. (

fig. 2) 

The “

On” light will turn blue.  If the 

light does not turn on, reference the 
troubleshooting section on page 11. 
(

fig. 3)

  Wait 30 seconds for the boiler to 

heat the water.  Pump the handle 
a few times to prime the pump, 
activate steam and moisten the 
micro-fiber pad. (

fig. 4) 

  Mop with a forward and backward 

motion to customize steam output 
automatically. (

fig. 5)

When you use your steam mop for the 
first time or if you have not used the unit 
in awhile, it may take a minute or two 
for the water to travel through the pump 
and into the heater to create steam.  Get 
it started by pumping the handle a few 
times.  If you have waited a few minutes 
and you still do not see any steam, 
reference the troubleshooting section 
on page 11. 

If your 

Light & Easy

™ 

Steam  

Mop stops steaming, it could 
be out of water.  Unplug the 
power cord from the electrical 
outlet and refill the water tank 
at anytime.

S3250W_11_IB_ENG_100505.indd   6-7

10-05-05   4:14 PM