GE Simon Security System ユーザーズマニュアル

You may use an off-site phone to arm/disarm your panel, turn lights on and off, check 
system status, or conduct an audio session (ask your installer if you have this feature).

¾

1.

Call the panel phone number and let the phone ring once then hang up.

2.

Wait 10 - 40 seconds and call the panel again.

3.

The panel should answer on the first ring. The panel will announce “System On”.

4.

Press the * button on your telephone and you will hear “System Activated”.

At this point you may perform the actions listed in the following table of phone com-
mands. CODE refers to the master and access codes programmed into your system.

If you are interactive with your panel and the panel hangs up on you, the system is 
calling in a report to the central monitoring station, pager or remote phone due to an 
action made by you or someone at the security system site.

Touchpads and keypads are used to control the security system from any location 
within or near your home.

Interfacing with the system using a Remote Handheld Touchpad and Dialog QS1500 
Touchtalk Interactive Keypad is similar to using the panel. 

Press System Status once to hear information about your system from the panel. See 
“Status Beeps”.

Press Arm Doors & Windows button once to turn the security system protection on 
for all protected doors and windows. 

DISARM

‚ + CODE + 1

ARM Doors/Windows

‚ + CODE + 2

ARM Doors/Windows with No Entry Delay

‚ + CODE + 2 + 2

ARM Motions

‚ + CODE + 3

ARM Motions with Latchkey

‚ + CODE + 3 + 3

ARM Doors/Windows and Motions

‚ + CODE + 2 + 3

ARM Doors/Windows with No Entry Delay 
and Motions with Latchkey

‚ + CODE + 2 + 2 + 3 + 3

Lights On/Off

‚ + CODE + 0

System Status

‚ + CODE + # + 1

AVM

‚ + CODE + 5 + X (X = a command 

from the Audio Verification Set, 1=Talk, 
2=VOX, 3=Listen)

Hang Up

‚ + CODE + 9 (Phone Command Mode)

‚ + 99 (AVM Mode)