Chauvet LED-FS1 ユーザーズマニュアル
Page 6 of 10
COLORstrip™ Footswitch User Manual Rev. 3
3.
S
ETUP
Power
The input power for the Foot Controller is provided by the COLORstrip™ product being
used. The included 6-pin DIN cable provides both power and signal between the
controller and the product.
used. The included 6-pin DIN cable provides both power and signal between the
controller and the product.
To determine the COLORStrip’s power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product’s back panel, or
refer to the product’s specifications chart. The listed current rating indicates the
product’s average current draw under normal conditions.
wiring), use the current value listed on the label affixed to the product’s back panel, or
refer to the product’s specifications chart. The listed current rating indicates the
product’s average current draw under normal conditions.
Always connect the COLORstrip™ to a protected circuit (circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Mounting
Before mounting the product, read and follow the safety recommendations indicated in
the Safety Notes.
the Safety Notes.
Orientation
The Foot Controller is designed for use on a floor or floor-like, horizontal surface.
Mounting overhead or vertically is not recommended.
Mounting overhead or vertically is not recommended.