3D Connexion ZT1000 ユーザーズマニュアル

zt1100/xz200 and xt1500 Series 

Removing and Replacing Parts 

43 

Troubleshooting and Self-Repair Guide 

 

•  Insert the connector end of the drive through the opening in the tray, then lower the drive into 

place. 

•  Carefully slide the hard drive assembly into its compartment. Press firmly to make sure the 

connector seats properly. 

 

If you are installing a new hard disk drive, install the factory software and operating system on the 
drive before loading any additional software—see “Recovering the Factory Software Installation” 
on page 37. 

 

Screws, 
M2.5x4mm (2) 

Screws, 
M2.5x4mm (2)