NuTone NC300 series オーナーマニュアル

Note: For the first two seconds, the tuner scans at slow speed

to allow for fine tuning. After two seconds, the tuner scans at

fast speed.

To preset radio stations:
1.  Press POWER to turn on the music.
2.  Select  FM  or  AM.  See  Music  Settings/Music  Source  for

instructions.

3.  Use TUNE UP or TUNE DOWN to find a station. See Tune

the Radio section for seek and scan functions.

4.  Simultaneously press TUNE UP and TUNE DOWN to enter

Store  Preset  mode.    The  display  shows  PRESET  and  a

preset number.

5.  If you don’t want to assign a preset number, wait 5 seconds

and your selected radio station will automatically be assigned

to the preset number that is displayed. If you want to select

the preset number, press the PRESET button repeatedly to

cycle through numbers1-8 until you reach the preset number

you want.

6.  Wait 5 seconds. The display updates to show the new station

for the selected preset number.

 Note:  This  activity  can  be  cancelled  at  any  time  during

the  process  by  pressing  TUNE  UP  and  TUNE  DOWN

simultaneously again, and no new preset is stored.

Two  scan  modes  are  available.  The  scan  mode  for  the  room

stations is set at the master. The two scan modes are identified

in the next figure. To set your scan mode:
•  Scan 1—Allows the Indoor/Outdoor Remote stations to scan

through  the  four  music  sources  (AUX,  AM,  FM,  CD).  On

radio bands AM and FM, Scan 1 scans through the preset

radio stations: AM 1-8 and FM 1-8. See Music Settings/Radio

Settings for information on how to preset radio stations.

•  Scan  2—Allows  Indoor/Outdoor  remote  stations  to  scan

through  the  four  music  sources  (AUX,  AM,  FM,  CD.)  On

radio  bands  AM  and  FM,  Scan  2  scans  all  strong  stations

before moving on to the next source.

To set the Scan Mode:
To  change  the  scan  mode,  simultaneously  press  and  release

PRESET and SOURCE again. The display shows either Scan1

or Scan2.
Note: Exit out of scan mode by pressing PRESET and SOURCE

or waiting for the display to show the clock time again.

•  Music—Adjusts the volume for system music.
•  Master Station—Adjusts the volume for the speaker on the

Master Station only.

•  Intercom—Adjusts the volume for the system intercom.