Magnavox MDR535H ユーザーズマニュアル

•  The clock may set itself automatically after you

connect the Antenna/Cable signal and plug in the AC
Power  cord.

•  For Analog auto clock setting, incorrect time may be

obtained depending on the broadcast information. If 
this occurs, set the “Auto Clock Setting” to “OFF” at
step 4 above and try “Manual Clock Setting” on page
34.

This unit can set the time and date automatically by referring to a channel that carries a clock information. If a PBS 
(public broadcasting station) is available in your area, follow “Auto Clock Setting” below. If not, follow “Manual Clock 
Setting” on page 34.

Make sure
•  The cable TV connections are correct.
•  Channels are set. (Refer to page 29.)

K/ L] to select 

“General Setting” menu will appear.

K /L] to select “Clock”, then

“Clock” menu will appear.

K /L] to select “Auto Clock 

K /L] to select “Auto”, then

y

y] to turn the

This unit will search for the time only when the
power is in the standby mode. Initially  leave it in
standby mode for at least 15 minutes to give this
unit time to set the clock. Once the clock is set, the
unit receives the clock data at 12:00 am & 12:00 pm
when unit is in standby mode. Check the time after
the Auto Clock was set, if it is incorrect time then set
the “Auto Clock Setting“ to “OFF” in step 4 above.
Then try “Manual Clock Setting“ on page 34.

E2S05_07_08UD_UH_MDR533_535_537H_EN_v2.indd   32

2013/02/12   21:06:17