Vision Fitness X6100 ユーザーズマニュアル

• With the screwdriver, remove the
screws for the water bottle cage in the
center of the console mast. Slide the
rubber boot onto the console mast.

• Unfold the wire harness located in
the frame bracket. Wrap the wire tie
around the end of the wire harness.
Pull the wire tie and wire harness up
through the top of the console mast
while simultaneously sliding the mast
into the frame bracket.

• Secure the mast to the frame using
three lock washers (8x14x1.5T) and
three capscrews (M8x60L). Tighten
with the 6mm L-Shaped wrench.

• Slide the rubber boot down the 
console mast and snap it in place on
top of the side cover.

• Remove the four screws from the
back of the console. Connect the wire
harness to the plug in the back of the
console. Connect the heart rate wires
from the console mast to the console.
Attach the console to the console mast
with the four screws. 

• Attach the water bottle cage with
the screwdriver and the screws removed
earlier in this step.