Patton electronic SmartNode 4110 Series ユーザーズマニュアル

IP interface configuration task list

SmartWare Software Configuration Guide 

Example: Create IP interfaces 

The procedure illustrated below assumes that you would like to create an IP interface named lan Use the fol-
lowing commands in administrator configuration mode.

node>enable
node#configure
node(cfg)#context ip router
node(ctx-ip)[router]#interface lan
node(if-ip)[lan]#

Almost every configuration command has a 

 form. In general, use the 

 form to disable a feature or func-

tion. Use the command without the 

 keyword to re-enable a disabled feature or to enable a feature that is 

disabled by default.

Deleting an existing interface in the IP context is often necessary.

Mode: Context IP

Example: Delete IP interfaces 

The procedure below assumes that you would like to delete an IP interface named external. Use the following 
commands in IP context configuration mode.

List the existing interfaces:

node(ctx-ip)[router]#interface <?>
  <interface>                 New interface
  lan                         Existing interface
  wan                         Existing interface
  external                    Existing interface
  internal                    Existing interface

Delete the interfaces named eth3 with the 

 command:

node(ctx-ip)[router]#no interface external

List the interfaces again to check if the appropriate interface was deleted:

node(ctx-ip)[router]#interface <?>
  <interface>                 New interface
  lan                         Existing interface
  wan                         Existing interface
  internal                    Existing interface

node(ctx-ip)[router]#no interface name Deletes the existing interfaces name