Patton electronic SmartNode 4110 Series ユーザーズマニュアル

IP interface configuration task list

SmartWare Software Configuration Guide 

Each IP interface needs its explicit IP address and an appropriate net mask to be set. You can use the 

 interface configuration command to perform the following tasks:

•

Set the IP address to ip-address 

•

Set the network mask to netmask

•

Enable IP processing for the IP interface name without assigning an explicit IP address

The 

 command offers the following options:

Mode: Context IP. This command also places you in interface configuration mode.

Example: Configure IP interface address and netmask 

To set the IP address to 192.168.1.3 and net mask to 255.255.255.0 for the IP interface lan, use the following 
commands in IP context configuration mode.

node(ctx-ip)[router]#interface lan
node(if-ip)[lan]#ipaddress 192.168.1.3 255.255.255.0

The NAPT allows one or more specific IP interfaces to be excluded from NAPT translations although their 
traffic is routed through an IP interface to which a NAPT profile is bound. This configuration is usually neces-
sary, for DMZ networks connected to an Ethernet port, which uses public IP addresses.

Mode: interface ip <if-name>

unnumbered Enables IP processing on an interface without assigning an explicit IP address to the inter-

face.

Specifies the IP address of the subscriber in the form A.B.C.D.

Specifies the network mask in the form A.B.C.D. 

dhcp

Enables the DHCP client on this interface. For more information on DHCP-client configura-
tion refer to chapter 27,

Selects the existing interface name, which shall be 
configured

Sets the IP address ip-address and netmask net-
mask for interface name

[name] (if-ip)[if-name]# [no] napt-
inside

If no napt-inside is specified, the interface is excluded from 
NAPT. if however napt-inside is specified, the interface will 
be handled normally by the NAPT.