Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Serial port configuration task list

SmartWare Software Configuration Guide 

Example: Disabling an interface 

The example shows how to disable the built-in serial interface on slot 0 and port 0 of a SmartNode. Check that 
State is set to CLOSED in the command output of 

.

node(cfg)#port serial 0 0
node(prt-ser)[0/0]#shutdown
node(prt-ser)[0/0]#show port serial

Serial Interface Configuration
------------------------------

Port            : serial 0 0 0
State           : CLOSED
Hardware Port   : V.35
Transmit Edge   : normal
Port Type       : DTE
CRC Type        : CRC-16
Max Frame Length: 2048
Recv Threshold  : 1
Encapsulation   :

After configuring the serial interface or connecting other serial devices, use the 

 command to 

enable the serial interfaces again. When you enable an interface, it has the state OPENED in the 

 command display.

Use the 

 command to disable the serial interface for any software 

or hardware configuration procedure.

This procedure describes how to enable a serial interface.

Mode: Administrator execution

Example: Enabling an interface 

The example shows how to enable the built-in serial interface on slot 0 and port 0. Check that State is set to 
OPENED in the command output of 

.

node(cfg)#port serial 0 0
node(prt-ser)[0/0]#no shutdown
node(prt-ser)[0/0]#show port serial

Serial Interface Configuration
------------------------------

Port            : serial 0 0 0
State           : OPENED

Selects the serial interface on slot and port

Enables the interface

node(prt-ser)[slot/port]#show port serial Displays the serial interface configuration.