Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Serial port configuration task list

SmartWare Software Configuration Guide 

Hardware Port   : V.35
Transmit Edge   : normal
Port Type       : DTE
CRC Type        : CRC-16
Max Frame Length: 2048
Recv Threshold  : 1
Encapsulation   :

The synchronous serial interface supports the Frame Relay and PPP serial encapsulation method. For more 
information how to configure Frame Relay and PPP, please see Chapter15,

To set the encapsulation method used by a serial interface, use the 

 interface 

configuration command.

This procedure describes how to set the encapsulation type of the serial interface.

Mode: Administrator execution

Example: Configuring the serial encapsulation type 

The following example enables Frame Relay encapsulation for the serial interface on slot 0 and port 0. Check 
that in the command output of 

 Encapsulation is set to framerelay.

node(cfg)#port serial 0 0
node(prt-ser)[0/0]#encapsulation framerelay
node(prt-ser)[0/0]#show port serial

Serial Interface Configuration
------------------------------

Port            : serial 0 0 0
State           : CLOSED
Hardware Port   : V.35
Transmit Edge   : normal
Port Type       : DTE
CRC Type        : CRC-16
Max Frame Length: 2048
Recv Threshold  : 1
Encapsulation   : framerelay

Only available on certain devices. 

Selects the serial interface on slot and 
port.

Sets the encapsulation type for the 
selected interface.

Displays the serial interface configuration.