Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Serial port configuration task list

SmartWare Software Configuration Guide 

Example: Configuring the active clock edge 

The following example enables to send data on the negative edge on slot 0 and port 0. Check that Transmit 
Clock is set to inverted in the command output of 

.

node(cfg)#port serial 0 0
node(prt-ser)[0/0]#transmit-data-on-edge negative
node(prt-ser)[0/0]#show port serial

Serial Interface Configuration
------------------------------

Port            : serial 0 0 0
State           : CLOSED
Hardware Port   : X.21
Transmit Edge   : inverted
Port Type       : DTE
CRC Type        : CRC-16
Max Frame Length: 2048
Recv Threshold  : 1
Encapsulation   : framerelay

A DCE interface has to provide the signal clocks. The desired baudrate can be configured. 

Only available on certain devices. 

This procedure describes how to set the baudrate for the serial interface.

Mode: Port serial

Example: Configuring baudrate to 64,000 bps

The following example configures a baudrate of 64,000 bps on the serial interface. Verify that the command 

 output displays the correct baudrate. True baudrate in the Status section shows the 

baudrate of the selected hardware.

node(cfg)#port serial 0 0

node(prt-ser)[0/0]#transmit-data-on-edge negative

node(prt-ser)[0/0]#show port serial detail 5

HDLC Driver: 0x8496b8

=====================

 Slot:                                  0

 Number of Ports:                       1

 Port: serial 0 0 0

 ------------------

Configures the baudrate for the serial interface.