Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Frame Relay configuration task list

SmartWare Software Configuration Guide 

After binding Framerelay PVC to an ip interface it must be enabled for packet processing. This procedure acti-
vates the PVC by opening the bound ip interface.

This procedure describes how to enable Framerelay PVC for packet processing

Mode: PVC

Example: Disabling a Frame Relay PVC 

The following example enables Frame Relay PVC with the DLCI 1 on the serial interface on slot 0 and port 0.

node(cfg)#port serial 0 0
node(prt-ser)[0/0]#framerelay
node(frm-rel)[0/0]#pvc 1
node(pvc)[1]#no shutdown

Check the PVC 1 status using 

 and verify that the entry no shutdown occurs in the con-

figuration part responsible for this PVC.

node(pvc)[1]#show running-config
Running configuration:
#----------------------------------------------------------------#
#                                                                #
…
pvc 1
  encapsulation rfc1490
  bind interface wan router
  no shutdown

Frame Relay PVCs can be disabled whenever it is necessary. Be aware that disabling a specific PVC also disables 
the related serial interface and vice versa.

This procedure describes how to disable the Frame Relay PVC DLCI on the serial interface.

Mode: PVC

Example: Disabling a Frame Relay PVC 

The following example disables Frame Relay PVC 1 on the serial interface on slot 0 and port 0.

node(cfg)#port serial 0 0
node(prt-ser)[0/0]#framerelay
node(frm-rel)[0/0]#pvc 1

Enables the Frame Relay PVC

Disables the Frame Relay PVC DLCI.