Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Frame Relay configuration task list

SmartWare Software Configuration Guide 

node(pvc)[1]#shutdown

Check the PVC 1 status by using 

 and verify that the entry shutdown occurs in the con-

figuration part responsible for this PVC.

node(pvc)[1]#show running-config
Running configuration:
#----------------------------------------------------------------#
#                                                                #
# 2500                                                           #
…
pvc 1
  encapsulation rfc1490
  bind interface wan router
  shutdown
  exit
…

A set of commands is available to check the status of the Framerelay connections, fragmentation process and 
keepalive message exchange. Be aware that some monitors generate a lot of output and can seriously impact 
your system performance.This procedure describes how to display the Frame Relay configuration settings for 
the serial interface

Mode: Administrator execution

Prints the status of the different monitors (ON or 
OFF)

Enables/Disables all framerelay debug monitors

Enables/Disables monitor which prints only 
occurred errors.

Enables/Disables monitor which prints keepalive 
events and messages

Enables/Disables monitor which prints management 
and configuration events

Enables/Disables monitor which prints dlci, size and 
fragmentation status of every incoming and outgo-
ing packet. Be aware that this monitor can seriously 
impact your system performance.