Patton electronic SmartNode 4110 Series ユーザーズマニュアル

PRI port configuration task list

SmartWare Software Configuration Guide 

RBS protocol. Enter the RBS configuration mode for RBS specific configurations (see Chapter 20,

Mode: channel-group group-name

The hdlc configuration mode can be entered either from the “port e1t1” configuration mode or from the 
“channel-group” configuration mode. If you cannot enter the hdlc mode, it may be due to an invalid or incom-
plete configuration, and an error message will be issued. In “port e1t1” configuration mode, you only need to 
set the encapsulation for ‘hdlc’ in order to enter the hdlc configuration mode. In “channel-group” configura-
tion mode the encapsulation must be set to ‘hdlc’ as well followed by configuring at least one timeslot per the 
‘timeslots’ command.

Mode: port e1t1 <slot> <port>

Mode: channel-group <group>

This command specifies the length of the checksum for calculating the CRC of the hdlc-frame. It can be either 
a 16-bit or a 32-bit checksum.

Mode: hdlc

[name] (ch-grp)[group-name]#[no] encap-
sulation {hdlc | q921 | rbs}

Specifies the encapsulation type of the channel-
group. Default: no encapsulation

[name] (prt-e1t1)[slot/port]# hdlc

Entering the hdlc configuration mode

[name] (ch-grp)[group-name]#hdlc

Entering the hdlc configuration mode

Selects the checksum-type to be used.
Default: crc16