Patton electronic SmartNode 4110 Series ユーザーズマニュアル

ページ / 664
Introduction
215
SmartWare Software Configuration Guide 
18 • ISDN Overview
Figure 33. Integration of ISDN access lines
Port activation deactivation—ISDN ports can be config-
ured while they are active. However they will be internally dis-
abled to modify the configuration and then re-enabled. All active 
calls on the port are dropped during this process. Configuration 
changes should only be performed during planned down times.
Reference clock source and synchronization—The 
SmartNode uses a single reference clock source for the synchro-
nization of the 64kbit/s PCM channels on the ISDN ports and in 
the CS context. This reference clock source can be internal or it 
can be derived from one of the ISDN ports. If the clock reference 
is not configured in accordance with the network environment, 
clock slips and related voice quality degradations can occur. 
Refer to chapter 31,
how to configure the reference clock
S/T
S
U
T
LE
Basic Rate Access point-to-multipoint (S-bus)
Basic Rate Access Line point-to-point
Primary Rate Access Line
PBX
Legend:
TE
Terminal Equipment (Phone)
NT1
Network Termination 1 (Modem)
NT2
Network Termination 2 (PBX)
V
TE
NT1
Local Exchange
TE
LT
ET
LT
ET
TE
Phones
Phone
NT2
NT1
NT2
TE
Phone
U
ET
S
T
PBX
LE
Local Exchange
LT
Line Termination
ET
Exchange Termination
T
Node
Node
Node
IP Network
Node
S/T
IP Network
IP Network
IMPORTANT
IMPORTANT