Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Basic IP routing configuration task list

SmartWare Software Configuration Guide 

The 

 form of the 

 command deletes a static IP route from the routing table. 

This procedure describes how to delete one or more static IP routes from the routing table

Mode: Administrator execution

Example: Deleting a static IP route 

In the following example, the route for packets to network 20.0.0.0/24, which are routed to device with IP 
address 172.17.100.2, shall be deleted.

node>enable
node#configure
node(cfg)#context ip router
node(ctx-ip)[router]#no route 20.0.0.0 255.255.255.0 172.17.100.2

This procedure describes how to display static IP routes

Mode: Operator or administrator execution

This command displays the destination address, next-hop interface, protocol (local, static, RIP, or ICMP), 
metric, flags (U–up, H–host, G–Gateway, L–local, D–default), and amount of use for each route in the routing 
table. If there are multiple routes to the same destination, the preferred route is indicated by an asterisk (*).

Example: Displaying IP route

In the following example, IP route information is displayed.

node>show ip route
Routes of IP context 'router':
Status codes: * valid, U up, H host, G Gateway, L local, D default
  Destination        Nexthop         Protocol  Metric  Flags     Used
---------------------------------------------------------------------
* 127.0.0.1/32                       local        0    LHG        n/a
* 172.16.40.77/32                    local        0    LHG        n/a
* 172.17.100.210/32                  local        0    LHG        n/a
* 172.17.100.0/24    wan             local        1    UL           0
* 20.0.0.0/24        172.17.100.2    static       0    U            0
* 172.16.0.0/16      lan             local        1    UL           6

Enters the IP router context

node(ctx-ip)[router]#no route network mask {address | interface} Deletes a static route

Displays IP route information