Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Examples

SmartWare Software Configuration Guide 

In this routing table two default routes (0.0.0.0/0) are defined. The first default route is valid for packets of the 
class local-voice only. The second default route is valid for all packets. Thus voice packets generated locally 
(traffic-class local-voice) will travel via the gateway (Nexthop) 172.16.32.1. All other packets will travel via the 
gateway (Nexthop) 172.16.32.2. 

NOTE:  If the second default route was missing, there would be no default route for packets of traffic-class 
other than local-voice. 

The following modified commands are used with policy routing: 

Route—refer to the ‘route’ command in the subsection 

chapter.

Ping—refer to the ‘ping’ command described in the subsection 

on page 127 in Chapter 10:  IP interface configuration. 

Traceroute—refer to the ‘traceroute’ command described in the subsection 

ter 10:  IP interface configuration. 

 shows an Internetwork consisting of three routers, a SmartNode device in the middle, and the four 

autonomous networks, with network addresses 10.1.5.0/16, 172.16.40.0/24, 172.17.100.0/24, and 10.2.5.0/
16. The SmartNode shall be configured for the following IP routing scenario:

All packets for the Workstation with IP address 10.1.5.10 shall be forwarded to the next-hop router Calvin. All 
packets for network 10.2.5.0/16 shall be forwarded to the next-hop router Hobbes.

Figure 37. Internetwork with three routers and four networks

Node

Node

172.17.100.2/24

172.17.100.1/24

172.16.40.1/24

172.16.40.2/24

10.1.5.2/16

10.2.5.2/16

lan

wan

Calvin

Hobbes

Hub

Hub

10.1.5.10/16

Workstation