Patton electronic SmartNode 4110 Series ユーザーズマニュアル
PPP configuration task list
324
SmartWare Software Configuration Guide
30 • PPP configuration
Displaying PPP configuration information
This section shows how to display and verify the PPP configuration information.
Mode: Configure
Example: Display PPP subscriber configuration information
node(session)[green]#show subscriber ppp joe_example
Subscribers:
------------
------------
Name: joe_example
Direction: dial-out
Authentication: pap
Identification (inbound): (none)
Identification (outbound): patton/patton
Timeout for disconnect: no absolute timeout, no idle timeout
Max. sessions: no limit
IP address: (none)
Callback: (none)
Binding: interface ppp_interface router
Binding: interface ppp_interface router
Direction: dial-out
Authentication: pap
Identification (inbound): (none)
Identification (outbound): patton/patton
Timeout for disconnect: no absolute timeout, no idle timeout
Max. sessions: no limit
IP address: (none)
Callback: (none)
Binding: interface ppp_interface router
Binding: interface ppp_interface router
Step
Command
Purpose
1
node(cfg) #show running-config
Gives the best overview of all PPP related configura-
tion information. The following parts are of interest:
tion information. The following parts are of interest:
•
profile ppp default
•
profile ppp name
•
interface name
•
subscriber ppp name
•
port ethernet slot port
•
session name
2
node(cfg) #show subscriber ppp [ name ] Displays configuration information of the PPP sub-
scriber name or of all PPP subscribers
3
node(pf-ppp)[name]#show profile ppp
{ name | default }
{ name | default }
Displays the PPP profile name or the default PPP
profile
profile