Patton electronic SmartNode 4110 Series ユーザーズマニュアル

PPP configuration task list

SmartWare Software Configuration Guide 

Example: Display a PPP profile

node(pf-ppp)[PPPoE]#show profile ppp PPPoE

Profiles:
---------

Name:                      default
LCP Configure-Request:     interval 3000 ms, max 10
LCP Configure-Nak:         max 5
LCP Terminate-Request:     interval 3000 ms, max 2
LCP Echo-Request:          interval 10000 ms, max 3
MTU:                       68 - 1920
MRU:                       68 - 1920
Callback:                  both
CHAP:                      allowed
PAP:                       allowed
Authentication:            interval 3000 ms, max 3
IPCP Configure-Request:    interval 3000 ms, max 10
IPCP Configure-Nak:        max 5
IPCP Terminate-Request:    interval 3000 ms, max 2
Van-Jacobson Compression:  allowed, max-slots 31
Van-Jacobson Decompression:allowed, max-slots 31

Name:                      PPPoE
LCP Configure-Request:     interval 3000 ms, max 10
LCP Configure-Nak:         max 5
LCP Terminate-Request:     interval 3000 ms, max 2
LCP Echo-Request:          interval 10000 ms, max 3
MTU:                       68 - 1492
MRU:                       68 - 1492
Callback:                  both
CHAP:                      allowed
PAP:                       allowed
Authentication:            interval 3000 ms, max 3
IPCP Configure-Request:    interval 3000 ms, max 10
IPCP Configure-Nak:        max 5
IPCP Terminate-Request:    interval 3000 ms, max 2
Van-Jacobson Compression:  allowed, max-slots 24
Van-Jacobson Decompression:allowed, max-slots 31
Van-Jacobson Decompression:allowed, max-slots 31

A set of commands is available to check the status of the PPP connection and the PPPoE session. Furthermore, 
two debug monitors help to analyze the dynamic behavior. The commands are listed in the order which you 
should follow in case you encounter problems with PPP. This procedure describes how to display PPP configu-
ration information