Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Configuring general CS settings

SmartWare Software Configuration Guide 

Mode: System

Debugging the clock source
To control the system behaviour at runtime, there exists a debug command with the options ‘event’ and ‘error’. 
If the user enables the ‘event’ command, he can follow the system’s Clock Source Hunting algorithm, the out-
put informs about the occurrence of a clock source change. In addition exists a ‘show’ command that prints the 
clock source configuration and marks the ports that are synchronized. Further, the port that has been chosen 
by the system as the current clock source will also be displayed.

Mode: Operator execution

Mode: Operator execution

node#show system-clock

Current clock source

====================

 t1 0 2 0

Registered clock sources

========================

 Name                        Sync

 e1 0 1 0

 t1 0 2 0                    X

 bri 0 3 0

 bri 0 3 1

 bri 0 3 2

 bri 0 3 3

 internal                    X

Add an entry to the end of the list

Overwrite and entry at position ‘index’

node(sys)#clock-source before index hw-type slot port Insert an entry before position ‘index’
node(sys)#clock-source after index hw-type slot port

Insert an entry after position ‘index’

Move entry at ‘index’ number of ‘posi-
tions’ up

Move entry at ‘index’ number of ‘posi-
tions’ down

Enables/Disables the system clock moni-
tor

Print system clock information