Patton electronic SmartNode 4110 Series ユーザーズマニュアル

FXO interface configuration task list

SmartWare Software Configuration Guide 

Example 1: Configuring an FXO interface which is to be connected to a PSTN network for analog line exten-
sion over IP. The FXS switch provides caller-id between the first and second ring and uses battery reversal to 
indicate a connected call. The FXO interface is named pstn-local. The incoming call is routed directly to the 
interface named pstn-1-voip. 

node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface fxo pstn-local
node(if-fxo)[pstn-local]#connect-signal battery-reversal
node(if-fxo)[pstn-local]#ring-number 2
node(if-fxo)[pstn-local]#route call dest-interface pstn-1-voip

Example 2: Configuring an FXO interface to be used as fallback if the IP network link is down. This means 
that there are only out-going calls. You are not sure whether the FXS switch provides a connect signal. In this 
case, you only have to create the interface and bind the FXO port to the FXO interface. (For binding the FXO 
port to the FXO interface, see chapter 44,

node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface fxo pstn-fb
node(if-fxo)[pstn-fb]#connect-signal battery-reversal
node(if-fxo)[pstn-fb]#connect-signal tax-pulse