Patton electronic SmartNode 4110 Series ユーザーズマニュアル

FXO interface configuration task list

SmartWare Software Configuration Guide 

Use the battery-reversal disconnect signal with caution, and use only if the 
battery-reversal connect signal is also enabled.

An FXO interface has the following methods for verifying the connection of an outgoing call after the dialing 
has been completed:

•

Detect battery reversal (if provided by the FXS switch)

•

Detect the first tax pulse (if provided by the FXS switch)

Tax Impulse Signals: European telephone companies in Austria, Belgium, 
Czechoslovakia, Germany, Spain and Switzerland place a pulse signal on the 
phone line to meter the length of the telephone call for billing purposes.

The command to enable or disable these methods is 

. If both are enabled, only one needs to 

occur for the FXO interface to verify a properly connected call with the remote party. Should both be disabled, 
the SmartNode waits for the call-connect signal from the FXS switch.

Mode: Interface FXO

Only disable connect-signal if you are sure that the FXS switch provides a 
call connect signal.

Basic prompt in Operator Exec mode

Enters Administration execution mode

Response: The prompt in administration 
execution mode is the #

Enters the Configure configuration mode

Response: The prompt in the Configure 
configuration mode is (cfg)#

Enters the Context CS configure mode

Response: The prompt in the Context CS 
configuration mode is (ctx-cs)[switch]#

Enter the Interface FXO configuration 
mode

Response: The prompt in the Interface FXO 
configuration mode is (if-fxo)[if-name]#

Selects battery-reversal, tax-pulse or nei-
ther to determine when outgoing calls are 
connected.
Default: both methods are disabled.