Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Call router configuration task list

SmartWare Software Configuration Guide 

The call router is able to accommodate almost every combination of these requirements through a customized 
configuration.

In order to keep this configuration compact we recommend that you first define the routing requirements and 
restrictions that apply to your installation. Then define the routing and mapping tables and the call services 
that you need to fulfill these requirements. Finally define the decision tree (i.e. the sequence in which the tables 
are linked together). In this step you may realize that you need multiple tables of the same type to achieve your 
goals. On the other hand an alternative sequence may help you to reduce the number of tables or the size of 
each table while still achieving the set goal. Only when you are happy with the planned tables, functions and 
sequence should you start configuration.

To activate the advanced call routing the first routing table in the CS interface has to be specified as you can see 
in 

. Make sure the route parameter on the CS interface is configured in order to forward the incoming 

calls to the first table of the call router. 

Procedure: To enable advanced call routing on a circuit interface

Mode: Context CS

Configure address completion timeout
A call that is routed through a called party number routing table possibly has a called party number that is too 
short for a routing decision to be made. In this case the call router waits for additional digits being entered by 
the calling user. When the user does not enter additional digits during the address completion timeout, the call 
router drops the call. You can configure the address completion timeout following the procedure below. The 
default address completion timeout is 12 seconds and is restarted after each digit that is sent during 
overlap dialing.

The address completion timeout is active when the call router waits for man-
datory digits before being able to complete call routing. Contrary to this, the 
digit collection timeout, described below, waits for additional optional digits.

Procedure: To configure the address completion timeout

node(ctx-cs)[switch]#interface if-type if-name

Change to Interface Configuration Mode to specify 
the entry table in the interface

node(if-type)[if-name]#route call dest-interface 
interface-name
or
node(if-type)[if-name]#route call dest-table 
table-name
or
node(if-type)[if-name]#route call dest-service 
service-name

Use these commands to route a call
(1) directly to an interface specified with the inter-
face-name parameter;
(2) to the call router, using the table-name table as 
first routing table;
(3) directly to a service specified with the service-
name parameter.