Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Call router configuration task list

SmartWare Software Configuration Guide 

The possible values for the type argument are:

•

transparent: Transparently passes an address-complete indication to the signaling-protocol (e.g. ISDN by 
sending a Sending Complete Information Element).

•

set: Always sends a Sending Complete Information Element with the SETUP message. This configuration 
can be used to disable overlap-sending on an interface.

•

clear: Never sends a Sending Complete Information Element. This configuration may be used in rare cases 
to solve interoperability problems with attached PBXs, e.g. when the attached PBX does not support the 
Sending Complete Information Element.

Some interface types do not support all arguments. SIP does not support this configuration at all, because SIP 
does not support overlap dialing. The following table shows the supported address-complete indication conver-
sion types and the default setting for each interface type:

The following procedure demonstrates how to disable overlap-sending for incoming SIP calls. SIP does not 
provide an overlap-dialing procedure; so for most applications, address-complete indications should be cleared.

Mode: context cs / interface sip

The following procedure demonstrates how to create a routing-table that allows overlap dialing. When the tim-
eout elapses or when the terminating-character is received, the address-complete indication shall be set toward 
the egress interface.

Mode: context cs

supported; default

supported

Supported

supported; default

supported

Supported

—

—

—

Clear the address-complete indication for all incoming calls 
over this interface 

Creates a routing-table that examines the called-
party number

Routes any number (after the waiting for digits) to the 
egress interface