Patton electronic SmartNode 4110 Series ユーザーズマニュアル

SIP location-service

SmartWare Software Configuration Guide 

Mode: Service SIP conference

Configuring the conference server
As described in the introduction, one of the responsibilities of this service is to build the conference server 
Request-URI according to RFC4240. The user part will be built from the called-e164 property and the serial 
number whereas the host part is specified by this command.

Mode: Service SIP conference

To avoid possible name conflicts, two expressions will be declared here. 
Location Service: Domain based identity data base. 
Service Location-Service: A call-route service that accesses the Location Ser-
vice declared above.

This service is the main consumer of the address bindings (mapping of the users identity to a contact address) 
deposited in the location service data base (see 51,

on page 607). Address bindings have 

been entered to location service data base either by inbound registration or manually by the user. An address 
binding is an entry that describes on which host a user is currently reachable. If a call is routed to this service, it 
performs a lookup with the requested URI to find the right contact information.

If the call is originated by the PSTN network, then this URI does not yet exist and must be built first with a 
mapping table. If this is not done, the lookup uses the called-e164 number and checks if a registered identity 
matches this number.  For more information about this process, see section,

It is also possible a user is registered with more than one contact. This can be if the user registers with its office 
SIP phone and also with its SIP soft client. In this case, the location-service's behavior can be configured. On 
the location-service, no routing command is available. The call will automatically be routed to that SIP inter-
face on which the register request has been received, therefore manually entered address bindings must be pro-
vided with a SIP interface as routing destination. 

[name] (svc-sip-conf)[name]#[no] route 
call dest-interface <name>
or
dest-table <name>
or
dest-service <name>

Specifies the next call routing destination for 
an incoming call. The no form of the com-
mand deletes the current routing entry.

Specifies the conference server host name 
and the port. The no form of the command 
removes the current entry.