Patton electronic SmartNode 4110 Series ユーザーズマニュアル

SIP location-service

SmartWare Software Configuration Guide 

Figure 75. Registration and Lookup

The following section describes how to create a new location-service and how to enter the configuration mode 
of an existing one. In addition, it describes all commands and sub commands of the location-service configura-
tion mode. All configuration tasks for a location-service are listed below.

•

Enter location-service configuration mode (see 

)

•

Bind a location service (see 

•

Configure multi contact behavior (see 

•

Configure the hunt timeout (see 

Entering SIP location-service configuration mode
The service sip-location-service command enters the configuration mode of an existing location-service or cre-
ates a new one with a specified name. It also destroys an existing service by using the no form of the command.

Mode: Context CS

Creates/Destroys a SIP location-service or 
enters the configuration mode of an existing 
one.

Location Service

Domain: 

biloxy.com

Context CS

Service

Location - Service

sip2

sip1

Lookup
Domain: biloxy.com
Identity: john.doe
 

Contact: 192.168.10.1:5060

Create address binding:
Identity: john.doe
Contact: 192.168.10.1:5060
Interface: sip1

REGISTER biloxy.com
From: john.doe@biloxy.com
To: john.doe@biloxy.com
Contact: 192.168.10.1:5060

INVITE sip:john.doe@192.168.10.1:5060

INVITE sip:john.doe@biloxy.com