Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Other FXS port parameters

SmartWare Software Configuration Guide 

This section describes the commands available for the configuration of an FXS port.

Procedure: Configure the FXS port parameters

Mode: Configure

Mode: IC voice in system

Enter FXS port configuration mode

node(prt-fxs) [slot/port]#[no] battery-
reversal

Reverses the line polarity at connect/disconnect of 
the call. This might be required by certain PBX to 
work correctly. Default: disabled.

node(prt-fxs) [slot/port]#end-of-call-sig-
naling
{ busy-tone |
  { loop-break <duration> } }

Selects the method how SmartNode signals the 
end of a call to the connected analog terminal, 
playing a busy-tone or interrupting the loop-current 
for a certain time (duration in ms). Default: busy-
tone.

node(prt-fxs)[slot/port]#caller-id for-
mat { bell | etsi }

Specifies which line protocol is used for caller-id 
transmission. Use bell for US/Canada, etsi for 
Europe.
Caller-id is enabled/disabled in the higher layer 
application (interface fxs in context CS). Default: 
etsi

node(prt-fxs)[slot/port]#[no] caller-id 
attenuation attenuation

Attenuates the modulated caller-id signal (dB). 
Default: disabled.

node(prt-fxs) [slot/port]#flash-hook-
duration duration

Specifies for what time the connected device goes 
on-hook for flash-hook signaling (ms). When enter-
ing this command without an argument, the default 
duration of 1000ms is applied. Default: 1000ms.
In US or Canada, try 350ms. To ensure that the 
flash-hook event can be relayed over SIP or H.323 
in analog line extension applications, disable all 
local call features in the fxs interface in the cs con-
text:  no call-waiting, no additional-call-offering, no 
call-hold.

node(prt-fxs) [slot/port]#[no] pulse-
dialing

Enables the port for use with pulse dialing termi-
nals. Recommended only when a terminal is con-
nected that allows pulse dialing only. Enabling 
pulse dialing disables the use of all flash-hook fea-
tures. Default: Disabled.