Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Configure country specific FXO port parameters

SmartWare Software Configuration Guide 

Unlike ISDN, POTS is heavily country specific even though there is a good chance that a setting for one coun-
try works reasonably good in another country. Country specific settings are contained in a so-called fxo profile 
which is integrated in the firmware of the SmartNode. It can be updated independently from the firmware by 
means of tftp download.

As there are over 190 countries SmartWare of course does not support all different country parameters. Thus 
before operation make sure that the country parameter for your country is available as profile. 

Procedure: Configure country specific FXO parameters

Mode: Port FXO

This section describes the commands available for the configuration of an FXO port.

Procedure: Configure the FXO port parameters

Enter configuration mode for FXO port

node(prt-fxo)[slot/port]#use 
profile fxo profile

Select a profile containing the country specific set-
tings of the port. Available profiles are:

•

‘etsi’ according to ETSI standard

•

‘fcc68_25Hz’ for the United States of America / 
Canada, according to the FCC86 standard, 
with 25Hz ringing detection.

•

‘fcc68_50Hz’ for the United States of America / 
Canada, according to the FCC86 standard, 
with 50Hz ringing detection.

•

‘tbr21_25Hz’, according to the TBR 21 stan-
dard, with 25Hz ringing detection.

•

‘tbr21_50Hz’, according to the TBR 21 stan-
dard, with 50Hz ringing detection.

The default profile (not displayed in the list when 
entering the command) is etsi.