Patton electronic SmartNode 4110 Series ユーザーズマニュアル
Other FXO port parameters
545
SmartWare Software Configuration Guide
44 • FXO port configuration
Mode: Configure
Step
Command
Purpose
1
node(config)#port fxo slot port
Enter FXO port configuration mode
2
optional
node(prt-fxo)[slot/port]#caller-id for-
mat { bell | etsi }
mat { bell | etsi }
Specifies which line protocol is used for caller-id
transmission. Use bell for US / Canada, etsi for
Europe.
If caller-id is not enabled or wrong configured,
detection of caller-id is not possible. Default: etsi
transmission. Use bell for US / Canada, etsi for
Europe.
If caller-id is not enabled or wrong configured,
detection of caller-id is not possible. Default: etsi
3
optional
node(prt-fxo) [slot/port]#flash-hook
duration duration
duration duration
Specifies for what time the SmartNode should go
on-hook to signal flash-hook to the CO. Default of
duration is 200ms, for US and Canada try 350ms
or higher.
on-hook to signal flash-hook to the CO. Default of
duration is 200ms, for US and Canada try 350ms
or higher.