Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Basic system management configuration task list

SmartWare Software Configuration Guide 

Example: Setting the system banner

The following example shows how to set a message for the system banner for your device, if you start from the 
configuration mode. 

node(cfg)#banner \n#\n# The password of all operators has changed\n# please contact 
the administrator\n#"

All SmartNode devices provide time-of-day and date services. These services allow the products to accurately 
keep track of the current time and date. The system clock specifies year, month, day, hour, minutes, and 
optionally seconds. The time is in 24-hour format yyyy-mm-ddThh:mm:ss and is retained after a reload.

Mode: Configure

The integrated SNTP client allows synchronization of time-of-day and date 
to a reference time server. Refer to chapter 26,

on page 282 for more details.

Example: Setting time and date

The following example shows the commands used to set the system clock of your device to August 6, 2001 at 
16:55:57, if you start from the operator execution mode.

node(cfg)#clock set 2001-08-06T16:55:57

This procedure describes how to display the current date and time

Mode: Both in operator and administrator execution

Example: Display clock information

The following example shows the commands used to display the time and date settings of your device in local 
time, if you start from the operator execution mode.

node>show clock
2001-08-06T16:55:57

Sets the system clock to yyyy-mm-ddThh:mm:ss

Display the local time.