Avaya 3600 Series ユーザーズマニュアル
Avaya Inc.
Desktop Charger, Dual Charger, and Quad Charger User Guide
Basic Operation
Turn the WT on Press and hold the
Power On
key for about one second, until two
chirps sound. Release the key. The in-service tone sounds and the
extension number displays. The WT is now in standby mode,
ready to make and receive calls.
extension number displays. The WT is now in standby mode,
ready to make and receive calls.
Turn the WT off While in standby mode, press and hold the
Power Off
key. One
chirp sounds and the WT turns off. The WT cannot be directly
turned off during a call. End the call first and then turn the WT
off.
turned off during a call. End the call first and then turn the WT
off.
Make a call or
go off hook
Press the
Start Call
key and then dial the number.
Select a line If multiple lines are available, your telephone system may require
you to select a line before dialing a number. Press the
LINE
key
and the number key of the line you wish to use. You will hear a
dial tone.
dial tone.
Dial a number Dial calls with the WT exactly as with your desk phone. You may
dial extension numbers, internal numbers, or make external calls,
depending on the setup of your PBX. You willhear a dial tone,
then press the number keys to dial the number.
depending on the setup of your PBX. You willhear a dial tone,
then press the number keys to dial the number.
Answer a call The WT will ring or vibrate to alert you to an incoming call.
Additionally, a line number on the display may flash, and the
display may show information about the call, such as caller’s
name and extension.
display may show information about the call, such as caller’s
name and extension.
To answer a call, press the
Start
Call
key, hold the earpiece to
your ear and speak with a normal tone of voice.
If you are on a call and hear subdued ringing, a call is coming in
on a second line. The line number on the display may be flashing.
To answer this call, put your first call on hold and press the
on a second line. The line number on the display may be flashing.
To answer this call, put your first call on hold and press the
LINE
key, then press the line number of the second call.
Headset answer When a headset is plugged into the WT, the
Start
Call
,
0 – 9, *
or
#
key may be pressed to answer a call.
Hang up To hang up, press the
End
Call
key. Be sure to do this at the end
of each call.
Unlock Keypad Press the
Unlk
softkey, then
#
, to unlock the keypad.
Lock Keypad Press
FCN
, then
Select
, to activate
Lock
Keys
on the Standby
menu.
Change speaker volume You may increase or decrease the volume of the speaker while in
a call by pressing the corresponding
Up
and
Down
buttons
located on the left side of the WT.
Change ring volume You may increase or decrease the ringing volume on the 3626
WT by pressing the corresponding
Up
and
Down
buttons located
on the left side of the handset while it is ringing.
Silence while ringing You may silence a ringing WT by pressing the
End
Call
button.
This action does not interrupt the call and the caller may leave a
voicemail message. Ringing volume may not be changed.
voicemail message. Ringing volume may not be changed.
Backlight The backlight comes on when any key is pressed or when there is
an incoming call and stays on for ten seconds. It turns off after ten
seconds if another key is not pressed within that period.
seconds if another key is not pressed within that period.
21-300632, Issue 1, July 2005
Page 10