AT&T 3.0 ユーザーズマニュアル

Call Accounting System

■   

CAS software

To use CAS for Windows with the system, the following components are

recommended:

■    

For a single-site system, an NCR 3315 PC (20-MHz 386) with 6 MB of

RAM and a 120-MB hard disk

■    

For a multi-site system, an NCR 3332 PC (66-MHz 486) with 16 MB of

RAM and a 340-MB hard disk

MS-DOS 5.0 or higher

— Windows 3.1 or later

■   

VGA color monitor

■   

Bus mouse

■   

For a single-site system, a 525-MB tape drive

■   

For a multi-site system, a 120-MB tape drive

■   

Okidata

® 

Microline 184T dot matrix or OL830 laser parallel printer

For communications using CAS for Windows, the following components are
recommended:

■    

For a single-site system, one parallel port and two built-in serial ports

(DB9 for direct switch connection and DB25 for other connections)

■    

For a multi-site system, one parallel port and a four-port Equinox

Mark-lV board with four RJ45 connections for direct switch hookup

■    

For remote diagnostics, a Remote Maintenance Board

■    

If a modem is used, an AT&T COMSPHERE 3830 or compatible

■    

If you are using the 9-pin port on your PC for the direct switch

connection, you need a DB9-to-modular adapter.

■   

An RJ45 modular cable to connect the PC’s COM1 port with the

control unit’s SMDR port

8-6 Installing Applications