Sharp PG-C20X ユーザーズマニュアル

4

3

3 Slide the ZOOM knob. The image can be adjusted

to the desired size within the zoom range.

4 Rotate the FOCUS ring until the image on the

screen becomes clear.

5 Press INPUT to select the desired input mode.

Press INPUT again to change the mode.

6

7

ON/OFF

POWER

LAMP

TEMP.

KEYSTONE

INPUT

BACK

ENTER

MENU

AUTO SYNC

8
7
5
6

8

• When the selected input signal is being received, “Adjusting

The Image” will be displayed.

• When no signal is being received, “NO SIGNAL” will be

displayed. When a signal that the projector is not preset to
receive is being received, “NOT REG.” will be displayed.

f

5

d

g

s

6 Press VOLUME on the remote control to adjust

the volume.

7 Press  AV MUTE on the remote control to

temporarily turn off the picture and the sound.
Press AV MUTE again to turn the picture and the
sound back on.

8 Press ON/OFF on the projector or POWER on the

remote control for over one second.
Press  ON/OFF or POWER again while the
message is displayed.

• If you accidentally pressed ON/OFF or POWER and do not

want to turn off the power, wait until the power off screen
disappears.

• When ON/OFF or POWER is pressed twice, the POWER

indicator will light up red and the cooling fan will run for
about 90 seconds. The projector will then enter standby
mode.

• Wait until the cooling fan stops before disconnecting the

power cord.

• The power can be turned on again by pressing ON/OFF or

POWER. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicator light green.

• The POWER indicator flashes if the right side filter cover is

not securely installed.