EIKI LC-X1UL ユーザーズマニュアル

USING THE PROJECTOR

TO TURN ON THE PROJECTOR

Connect the projector to a video source (Computer, VCR, Video Camera, Video Disc Player, etc.) using the
appropriate terminals on the side of the projector (See “CONNECTING THE PROJECTOR” section on pages 9-16).

Connect the projector’s AC power cord into a wall outlet and turn the MAIN ON/OFF switch (located on the side of

the projector) to the ON position. The LAMP POWER indicator will light RED, the READY indicator will light

GREEN.

Press the LAMP POWER ON/OFF button on the remote control unit or on the

projector to ON. The LAMP POWER indicator light will dim and the cooling fans will

operate, The count-down display appears on the screen and the count-down starts (30-

29-28-...1). The signal from the video source appears after 30 seconds.

CAUTION:

THIS PROJECTOR USES A METAL-HALIDE ARC LAMP. TO EXTEND THE LIFE OF THE

LAMP, ONCE YOU HAVE TURNED IT ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING

IT OFF.

NOTE: TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off.

Wait at least 5 minutes before turning the projector on.
If the TEMPERATURE WARNING INDICATOR continues to flash, follow the procedures below:
(1). Press LAMP POWER ON/OFF button to OFF.
(2). Check the air filter for dust accumulation.
(3). Remove dust with vacuum cleaner (See “AIR FILTER CARE AND CLEANING” section on page 50.)

(4). Press LAMP POWER ON/OFF button to ON.

If the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized dealer or
service station.

TO TURN OFF THE PROJECTOR

Press the LAMP POWER ON/OFF button on the remote control unit or on the

projector. The “Power off ?“ appears on the screen. Press again the LAMP POWER

ON/OFF button to turn OFF the projector. The LAMP POWER indicator will light

bright and READY indicator will turn off. The cooling fans will operate for 1 minute

after the projector is turned off. (During this “cooling down” period, the projector

cannot be turned on.) The READY indicator will light green again and the projector

may be turned on by pressing the LAMP POWER ON/OFF button. To power down

completely, turn the MAIN ON/OFF switch (located on the side of the projector) to the

OFF position.

DIRECT OPERATION
MODE SELECT

Press the MODE button (located on remote control unit or on the projector) to select

Computer 1, Computer 2, Video 1 or Video 2 Input. The “Computer 1”, “Computer 2”,

‘Video 1” or “Video 2” display will appear on the screen for a few seconds.