EIKI LC-X1UL ユーザーズマニュアル

 

 

 

Press the VOLUME buttons (located on remote control unit or on the projector) 

to adjust the volume. The volume display will be displayed on the screen for a 

few seconds. 

Pressing volume (÷) will increase volume and increase the number on the screen. 

Pressing volume (-) will decrease volume and decrease the number on the 

screen. 

Pressing the MUTE button on the remote control unit will mute audio. Press the 

MUTE button again to restore audio to its previous level. The mute display will 

be displayed on the screen for a few seconds. 

(Top control and Wireless/Wired remote control unit) 

Press the ZOOM (+) or (-) button to obtain your desired picture size. For a larger picture, 

press (+) and for a smaller picture, press (~—). 

 (Wireless remote control unit) Press the ZOOM button 

and press POINT UP/DOWN button(s) to obtain your desired picture size. The 

Zoom display will be displayed on the screen for a few seconds. For a larger 

picture, press (UP) and for a smaller picture, press (DOWN). 

 (Top control and Wireless/Wired remote control unit) 

Press the FOCUS (+) or (-) button for a sharper, crisper picture. 

 (Wireless remote control unit) 

Press the FOCUS button and press POINT UP/DOWN button(s) to obtain a sharper, 

crisper picture. The Focus display will be displayed on the screen for a few seconds. 

 (Top control and Wireless/Wired remote control unit) 

Press the LENS SHIFT (+) or (-) button to obtain your desired screen position. 

 (Wireless remote control unit) 

Press the LENS SHIFT button and press POINT UP/DOWN button(s) to obtain your 

desired screen position. The Lens shift display will be displayed on the screen for a few 

seconds. 

The normal picture level is factory preset on the projector and can be restored anytime by 

pressing the NORMAL button (located on remote control unit or on the projector). The 

“Normal” display will be displayed on the screen for a few seconds. 

Press the NO SHOW button on the remote control unit. The screen will change into black image and the “NO SHOW’ 

is displayed on the screen for a few seconds. 

This function is cancelled when the NO SHOW button is pressed again or any other 

function button is pressed. 

Press the P-TIMER button on the remote control unit. The timer display “00:00” appears 

on the screen and the timer starts to count the time (00:00-59:59). Press again the P-

TIMER button to stop the timer. Then press the P-TIMEA button to cancel the P-TIMER 

function. 

Press the FREEZE button on the remote control unit, and the picture will remain on-screen. This function is cancelled 

when the FREEZE button is pressed again or any other function button is pressed. 

 

NOTE: Your computer or video equipment is not affected by this function, and will continue to run. 

Press the AUTO IMAGE button on the remote control unit or on the projector. The item(s) indicated “ON” in the 

AUTO IMAGE FUNCTION are adjusted automatically. 

If all the items in AUTO IMAGE FUNCTION are “OFF”, AUTO IMAGE SETTING display appears. If you wish to 

operate the AUTO IMAGE FUNCTION, perform the steps 3 - 9 of “AUTO IMAGE FUNCTION” section on page 

39.