Invacare R121 ユーザーズマニュアル
ACCESSORIES
43
Installing the Reliant Scale
WARNING
Patient and sling MUST be removed from the lift during ALL installation proce-
dures.
NOTE: For this procedure, refer to FIGURE 8.2.
1. Position the load cell assembly of the Reliant Scale into the boom mounting bracket.
Refer to Detail ʺAʺ.
NOTE: Use 1/4‐inch nylon washer.
2. Secure the Reliant Scale to the boom mounting bracket with a shoulder bolt, two nylon
washers and a locknut. Securely tighten. Refer to Detail ʺAʺ for washer orientation.
NOTE: Ensure the shaft of the shoulder bolt passes through both sides of the boom mounting
bracket.
bracket.
3. Insert swivel bar pin with two nylon washers through the swivel bar. Refer to Detail
ʺBʺ.
4. Align the mounting holes in the swivel bar pin with the mounting holes in the load
cell assembly. Refer to Detail ʺBʺ.
5. Secure swivel bar pin to the load cell assembly with the provided mounting screw and
locknut. Securely tighten. Refer to Detail ʺBʺ.
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
6. Weigh the patient. Refer to Operating the Scale on page 44 and Weighing the Patient
FIGURE 8.2 Installing the Reliant Scale
Locknut
Swivel Bar
Nylon
Washers
Swivel Bar
Pin
Mounting
Screw
Boom
Reliant
Scale
Boom
Mounting
Bracket
Reliant
Scale
Nylon
Washer
Load Cell
Assembly
Assembly
Shoulder
Bolt
DETAIL “B”
DETAIL “A”
Locknut
Nylon
Washer