Peerless Industries SA771PU 사용자 설명서

ISSUED: 10-30-09   SHEET #: 095-9299-11  03-22-12

CENTER DISPLAY BRACKETS VERTICALLY ON BACK OF DISPLAY

DISPLAY

DISPLAY BRACKETS

"Y" dimensions should be equal.

NOTE: "X" dimensions should be equal.

•  Tighten screws so display brackets are fi rmly attached to display. Do not tighten with excessive force. 

Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing 
screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

•  If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly 

secured, damage may occur to display or product may fail.

Select the screws from the baffl ed fastener pack that best fi t your display and secure to display following step 3-4 
or 3-5 on page 11. 

NOTE: Top and bottom mounting holes must be used for attaching display brackets. Middle holes should also be 
used where the fasteners and displays allow.

Verify that all holes are properly aligned, then tighten screws using a phillips screwdriver.