Peerless Industries PT640 사용자 설명서

ISSUED: 10-31-07  SHEET #: 202-9242-2 03-20-08

Visit Peerless website at www.peerlessmounts.com

For customer care call 1-800-729-0307 or 708-865-8870

• Always use an assistant or mechanical lifting equipment

to safely lift and position the flat panel screen.

• Do not tighten screws with excessive force. Overtightening

can cause damage to mount.

 Tighten screws to 40 in. • lb

(4.5 N.M.) maximum torque.

• Be careful not to pinch fingers when pushing screen from

the bottom.

For preset tilt angles use Increlok

™ and for

custom tilt angle use ratchet handle.

: The screen can be locked into a

pre-set tilt position of -5

°

, 0

°

, 5

°

, 10

°

 or 15

°

. Use

locator hole to find tilt position hole and tilt screen
to align holes. Tighten IncreLok™ tilt locking
screws on both tilt brackets to lock tilt as shown in
detail 2.

 

Loosen ratchet handle (refer to

step 3 for tension adjustment of handle). 

Push or

pull from top or bottom of screen to adjust tilt as
shown in fig. 4.1. The tilt can be adjusted to a
maximum of 15° forward or 5° backward.

 Adjust

tension in tilt brackets (BB & CC) by rotating
ratchet handle. NOTE: If obstruction prevents
ratchet handle from rotating, pull handle out while
turning will allow handle to reposition without
tightening. Release and turn handle to tighten or
loosen.

Mounting Screen: Ratchet handle must be in the
up or down position or interference will occur while
hooking tilt brackets to wall plate (AA). Slowly hook
tilt brackets (BB & CC) onto wall plate (AA) and
swing screen down as shown in fig. 3.1. Tilt bracket
hooks must fully engage wall plate as shown in
detail 1. Using phillips screw driver, turn safety
screws on tilt brackets (BB & CC) clockwise till
screw tip securely contacts wall plate as shown in
cross section.

Screen Adjustment: Screen can be adjusted
horizontally by loosening safety screws on tilt
brackets (BB & CC) three full turns with phillips
screw driver. Adjust screen as shown in fig. 3.2.
Tighten safety screws on tilt brackets till screw tip
securely contacts wall plate as shown in cross
section.

Removing Screen: To remove screen from mount,
loosen safety screws, swing screen away from
mount, and lift screen off of mount.

© 2007, Peerless Industries, Inc. All rights reserved.

All other brand and product names are trademarks or registered trademarks of their respective owners.

IncreLok™

TILT LOCKING

SCREW

 LOCATOR

HOLE

RATCHET

HANDLE

TILT

POSITION

HOLES

3

4

RATCHET

HANDLE

SAFETY
SCREW