Peerless Industries PP730-S 사용자 설명서

6 of 20

ISSUED: 10-01-07 SHEET #: 095-9272-2 06-15-09

NOTE: Adjustment points (socket screws) are factory torqued for optimal performance. This factory torque setting is

recommended to prevent the screen from slipping over time. If more or less tension is desired follow this optional step.

You may not achieve optimal torque value if factory torque settings are adjusted.
If more or less tension is desired in tilt mechanism, remove snap caps as shown in detail 2. Insert a flat head

screw driver into slot and pry cap away from tilt mechanism:

• To adjust tilt, simply tighten or loosen socket screw no more than half a turn using 5 mm allen wrench (

E).

• To adjust roll, simply tighten or loosen 10-32 nylock nut.

OPTIONAL

• Do not loosen socket screws or nylock nuts to the point they become disengaged from the mount. Doing so may

cause the screen to fall.

WARNING

SNAP CAP

SOCKeT
SCREW

10-32 NyLOCK NUT

DETAIL 2

SLOT

If more or less tension is desired in the arm pivot points,

do the following:

• To increase tension, turn socket screw clockwise with

3/16" allen wrench (

I).

• To reduce tension, turn socket screw counter-clockwise with

allen wrench (

I).

NOTE: Do not turn more than half a turn.

SOCKeT SCreWS

All other brand and product names are trademarks or registered trademarks of their respective owners.

Peerless Industries, Inc.

3215 W. North Ave.

Melrose Park, IL 60160

www.peerlessmounts.com

Attach cable tie anchor (

H) to top or bottom of wall arm (AA) using M4 screw (M) as shown in figure 3.1. Secure

cables to wall arm (

AA) using cable tie (G) as shown in figure 3.2.

Cord Management

fig. 3.1

SCreeN

CABLES

fig. 3.2