Peerless Industries ACC925 사용자 설명서

4 of 9

ISSUED: 11-19-08 SHEET #: 120-9062-3 06-29-12

Visit the Peerless Web Site at www.peerless-av.com

For customer care call 1-800-865-2112.

For Flat Back Screen

For Bump-out or Recessed Back Screen

Begin with the shortest length screw, hand thread through multi-washer and flat or tilt adapter bracket (not
included) into screen as shown below. Screw must make at least three full turns into the mounting hole and fit
snug into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length
screw from the security fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of screen.

Begin with longer length screw, hand thread through multi-washer, flat or tilt adapter bracket (not included) and
spacer in that order into screen as shown below. Screw must make at least three full turns into the mounting hole
and fit snug into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer
length screw from the security fastener pack. Repeat for remaining mounting holes, level brackets and tighten
screws.

2-1

2-2

If you have any questions, please call Peerless customer care at 1-800-865-2112.

FLAT
BRACKET

SCREEN

MULTI-WASHER

SCREW

SCREEN

MULTI-WASHER

SCREW

TILT
BRACKET

FLAT
BRACKET

SCREEN

SPACER

MULTI-WASHER

SCREW

ADAPTER
BRACKET

SCREEN

SPACER

MULTI-WASHER

SCREW

TILT BRACKETS

FLAT BRACKETS