Peerless Industries DS-VL-H024 사용자 설명서

ISSUED: 06-04-10  SHEET #: 120-9084-1

•  Do not begin to install your Peerless product until you have read and understood the instructions and warnings 

contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please 

call Peerless customer care at 1-800-865-2112.

•  This product should only be installed by someone of good mechanical aptitude, has experience with basic building 

construction, and fully understands these instructions.

•  Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-

ware and components.

•  Never exceed the Maximum Load Capacity. See page 1.
•  If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of 

an "edge to edge" stud finder is highly recommended.

•  Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•  Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding 

power.

•  This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal 

injury.

•  This product was designed and intended to be mounted to the following supporting surfaces checked below with 

the hardware included in this product as specified in the installation sheet. To mount this product to an alternative 

supporting surface, contact Peerless customer care at 1-800-865-2112.

•  This product was designed to be installed on the following wall construction only;
 

  x  Wood Stud 

 

 

None

 

x  Wood Beam 

 

 

None

 

x  Solid Concrete   

 

Contact Customer Service

 

x  Cinder Block   

 

Contact Customer Service

   

Metal Stud 

 

 

Do not attach except with Peerless accessory kit for metal studs; 

 

 

 

 

 

Contact Customer Service for Peerless accessory kit for metal studs.

   

Brick   

 

 

Contact Customer Service

   

Other or unsure? 

 

Contact Customer Service

NOTE: Read entire instruction sheet before you start installation and assembly. 

•  stud finder ("edge to edge" stud finder is recommended)    
•  5/16" socket wrench
•  drill    
•  level
•  5/32" drill bit for wood studs
•  5/16" drill bit for concrete

Parts List.................................................................................................................................................................................3
Installation to Wood Stud Wall ................................................................................................................................................4
Installation to Solid Concrete/Cinder Block walls ...................................................................................................................5

Accessories:  

•  DS-ACC-LDCM

   cable management accessory (optional)

•  ACC-DSV240 adapter brackets (optional)  

•  ACC-DSV329 adapter brackets (optional)  

•  ACC-DSV499 adapter brackets (optional)  

•  ACC-DSV503 adapter brackets (optional)  

•  ACC-DSV745 adapter brackets (optional)